* Simulates CO and PBX operation at the customer Network Interface.
* DS1, DDS, Program, Tie Line, DID, OPX, FXO, Equal Access, E911 and many others.
* Both Analog and Digital (DS1) Circuit Access in one test set.
* Full integration of analog functions into selected DS0 channel.
* Independent Dual Drop & Insert Operations for DS1/DS0.
* DS1 Channelized and Analog testing at it’s best.
The BE9000-L3 (Base Unit) is the analog test set. The digital interface (Digital Package) is mounted in the lid. The BE9000-L3 can be purchased without the Digital Interface. The Digital Interface is also available separately as our BTS1000 BERD DAWG Communications test set.
BE9000-L3 carry a two-year warranty.
DIMENSIONS: With the Digital Package installed the test set weighs 16 pounds. Measurements are 13 inches in height, 13 � inches in width, and 8 inches deep. The face plates each measure 13 � inches by 8 inches. Call 402-426-3700, EMAIL email@example.com, or FAX 402-426-3705 for prices
BE9000-L3 DEMARCATION TEST SET
The Wide Area Network (WAN) circuit provider and the user of that network can no longer tolerate the inefficiency of the argument about where the problem is. Because the BE9000 method of operation is the same as the circuit, dates for circuit cutover, equipment installation and circuit restoration can be met with a minimal chance of recall.
DS1, DS0 and analog transmission measurements can be performed. The DS1 and DS0 transmission measurements are made either in an IN-SERVICE (non intrusive monitoring), or OUT-OF-SERVICE (Drop & Insert) mode. The test set will automatically configure to the SF and/or ESF frame formats, and will automatically detect B8ZS occurrences. Also, alarm and error occurrences which impact circuit performance are displayed in an easily understood manner. Analog measurements can be performed that require test results utilizing frequencies from 204 to 9999 kHz. Three levels of noise tests and impulse noise tests can be performed.
If the test interface is digital or analog, these signaling interfaces: Loop Start, Ground Start, E&M Type I & II and Wink Start, SX & SF can be simulated in either an originating or terminating configuration. Additionally, monitoring of these signaling interfaces allows the user to determine lead status and timing relationships under normal operating conditions.
Monitoring and/or sending and receiving MF, DTMF or DP address digits can be performed. The receive rate and the % Break of DP digits can be analyzed. The rate at which MF and DTMF digits are received is displayed. All address digits can have the send rate varied from 8 to 20 Pulses Per Second (PPS).
Ringing is generated at a 20 Hz or 30 Hz rate superimposed on battery. A ringer load of REN3 is used to determine if the received ringing is above the required threshold. Ringing voltage level and ring trip current are accurately measured.
When the BE9000 is equipped with the Digital Package (DP) Option, a full range of channelized tests can be performed. Circuits can be tested and turned up for service. The primary benefit of utilizing the BE9000 to test the listed applications is the increased capability, flexibility and productivity of testing.
When using the Dual Drop & Insert (Digital Package) option, a technician can:
Call 402-426-3700, EMAIL firstname.lastname@example.org, or FAX 402-426-3705 for prices
The BE9000, like all Berry products, provides user interface & price features unique in the marketplace.
ADDITIONAL CONSIDERATIONS: *The BE9000-L3 carry a two year warranty. *Training for first time users is provided at no cost to the user. *Technical Support is available during regular business hours. (Special arrangements for assistance after hours). *Repair services are available. *Lease and Lease-to-Purchase options are also available.
OPTIONS/UPGRADES: All options can be added to a BE9000-L2 or BE9000-L3 at any time.